Slicer Discord
Alunar XY Axis Alignment braces – 3D-printbaar model van Thingiverse Thingiverse

Alunar XY Axis Alignment braces

door jmperry71
59 Downloads
41 Likes
0 Makes
Model downloaden
The Alunar is a great budget printer but the XY axis were not orthogonal and need to be squared up to produce more accurate parts. These parts mount on the front base plate threaded rods (inboard side of the base) and on the z axis guide rods at the bottom. Use a piece of 5/16-18 all-thread rod cut to 9.5 inches length and then use them to push or pull the X and Y axis into alignment. You will have to loosen the center nuts on the base threaded rods to allow the y axis to move and them re-tighten after it is aligned. To square the bed out I suggest using a 6 inch machinist square short side on the X axis guide rods and slide the y axis back and forth checking for a parallel clearance to the bed edge through out the travel. If you bed is crooked align it to the y axis first and then repeat the above process and adjust the nuts on the new threaded rods equally on both sides (one pushing and one pulling) until it is square. I was able to achieve a nearly perfect square by visual inspectio
Bron
Thingiverse
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Eendelig Hardware nodig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 1/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Nabewerking
Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie