Thingiverse
AM8 mk3 Clamp
door Mathew96
3
Downloads
3
Likes
0
Makes
This clamp is made to secure the Y-rods on an Anet-AM8, as the original ones are too high to be used with the i3 mk3 bed as it is lower than the Anet bed. They are a drop-in-replacement, you can simply switch your existing clamps with these. It might be neccessary to sand them a bit on top. For me this was not the case but it might happen as there is little space between the rods and the carriage.
Have fun!
Have fun!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
