Thingiverse
Amazon Echo Dot (3rd Gen) mouldable hang mount
by SPANKiE101
1
Downloads
0
Likes
0
Makes
Simplified version of leefla's design, made to hang from the top of a dresser.
Rather than designing the correct sized hook, I left that part of the model flat, so that a hairdryer can be used to soften the plastic and then mould it by hand directly over the place where it will hang.
I also increased the dimentions slightly, so that the legs should no longer snap off when placing the Echo Dot inside the mount (untested).
Fusion 360 > Modify > Scale > 1.0027
The inner diameter is now 9.9cm (2.5mm larger) aprox.
Rather than designing the correct sized hook, I left that part of the model flat, so that a hairdryer can be used to soften the plastic and then mould it by hand directly over the place where it will hang.
I also increased the dimentions slightly, so that the legs should no longer snap off when placing the Echo Dot inside the mount (untested).
Fusion 360 > Modify > Scale > 1.0027
The inner diameter is now 9.9cm (2.5mm larger) aprox.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
