Amcrest Angled Camera Box

I created this camera box because I needed to set the camera on top of a horizontal surface and I couldn't tilt the lens down far enough to get the angle I wanted. I needed it for a customer's installation and I didn't have the camera in my hand to test the fit with before install. It ended up to be about 2cm to small in diameter to match the outside diameter of the camera but it bolted up and works fine.

I needed it to fit an IP8M-T2599EW camera. However, the specs in the Amcrest docs for this camera are obviously incorrect. I found a picture of a similar camera and dimensions that I used and that's why the box ended up to be smaller.

Screw holes fit 4mm x 5mm screws and they self thread into the holes. The angle of the top of the box is 15 degrees

I got my inspiration from this design but ended up designing from scratch myself... https://www.thingiverse.com/thing:5436317

Printed on Ender 3 S1 Pro using Overture Matte Black PLA using 20% infill. I used a 4mm brim ju