Thingiverse
AMD CPU Holder/Box
by Ampera
106
Downloads
96
Likes
1
Makes
This is a neat little box you can use to store a CPU in. This should fit most AMD CPUs, but it will definitely fit 754, 939, AM2, AM2+, AM3, and AM3+. It might fit FM1, FM2, FM2+, or AM1, but I haven't tried it out. It may also hold other CPUs of the same size.
You may have to rotate this in your printing software. I had to in XYXware Pro, but it shouldn't be hard to do.
I test printed this using a blue PLA, on an XYZPrinting Da Vinci Jr. 1.0 Pro at 200c, with no supports, no rafts, and 10% infill. Should work fine using any plastic or infill type, but I recommend 10%.
The holder is in two parts, each a different STL file, and I recommend printing separately. The bottom piece is 10mm high, and the top is 12.5mm high. The inside is 10mm tall. The box is 48x48mm large, and the inside is 42x42. Filing may be needed on some of the inside parts depending on the quality of your 3D printer. I just had to file down a bit of sprew-like pieces that shouldn't be there.
The box should
You may have to rotate this in your printing software. I had to in XYXware Pro, but it shouldn't be hard to do.
I test printed this using a blue PLA, on an XYZPrinting Da Vinci Jr. 1.0 Pro at 200c, with no supports, no rafts, and 10% infill. Should work fine using any plastic or infill type, but I recommend 10%.
The holder is in two parts, each a different STL file, and I recommend printing separately. The bottom piece is 10mm high, and the top is 12.5mm high. The inside is 10mm tall. The box is 48x48mm large, and the inside is 42x42. Filing may be needed on some of the inside parts depending on the quality of your 3D printer. I just had to file down a bit of sprew-like pieces that shouldn't be there.
The box should
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!