Thingiverse
Electronics
Zum Modell
AmmoCounter Universal Kit 3.0 Case
78
Downloads
63
Likes
0
Makes
Universal Kit 3.0 for AmmoCounter V3 Kits available at http://ammocounter.com
IMPORTANT - This print requires a standalone AmmoCounter V3 kit.
Print the face with supports.
Choose a case and print buttons.
Trim any loose plastic with a hobby knife.
Insert buttons, they should slide freely. If not, repeat step 2.
Install the V3 kit by pressing into the back of the bezel mount.
Insert AmmoCounter V3 kit.
Insert finished face mount assembly and add 2 Nerf type screws.
Printed at 35% infill and 2 shells on a Makerbot 5th generation.
Please do not sale this design or any remix without written permission from AmmoCounter.
Contact us at http://facebook.com/AmmoCounter with questions!
IMPORTANT - This print requires a standalone AmmoCounter V3 kit.
Print the face with supports.
Choose a case and print buttons.
Trim any loose plastic with a hobby knife.
Insert buttons, they should slide freely. If not, repeat step 2.
Install the V3 kit by pressing into the back of the bezel mount.
Insert AmmoCounter V3 kit.
Insert finished face mount assembly and add 2 Nerf type screws.
Printed at 35% infill and 2 shells on a Makerbot 5th generation.
Please do not sale this design or any remix without written permission from AmmoCounter.
Contact us at http://facebook.com/AmmoCounter with questions!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
