Amplifier Case for PAM8610 Module

Printed to house an amplifier board I had. This was a one-off but some people expressed interest in my case. So, here it is.

https://www.amazon.com/HiLetgo-PAM8610-Digital-Amplifier-Channel/dp/B00WSN9S4Q/

The board is 25x30 mm and friction-fits in the spot on one half of the case.

Hardware needed:

1x of each STL file on this Thing
4x 4-40 x 1/2 inch screw (I haven't tried M3 screws but M3-12mm should work)
1x 4-40 tap to thread holes (see note above)
2x RCA female jacks for speaker output
1x 3.5mm TRS female jack for audio input
1x 5mm LED for power indicator
1x switch with 6mm threaded bushing
1x DC power jack (5.5 x 2.1 mm) with 12mm threaded bushing
Hookup wire / heatshrink tubing as needed
Solder