AMS 2 Pro Lid Riser for Larger Spools

by maxim3D · 3D Printer Accessories

350 Downloads

114 Likes

148 Makes

This is a simple but effective mod for the new AMS 2 Pro. It allows you to use larger spools while still keeping the AMS 2 fully sealed and without scratching the lid. This is based on the V1 lid riser by DesignCraft, so all credit to him for the original design and inspiration. I have been using his AMS 1 risers on my X1 and P1s with great success, and wanted the same setup for the AMS 2 Pro but found out the lid size was different so I made this model. TPU for AMS is the ideal material for this as it has some flex. IMPORTANT NOTE!: Some people have commented about not getting a good seal. This is due to improper installation. You need to apply a good amount of pressure so the bottom rib goes all the way into the rubber gasket on the AMS. Click here to check out my AMS HT lid riser.