AMS DECO - CUSTOMIZABLE FRAME

Introduction: The AMS DECO is a super simple design and print for the sole purpose of pimping out your X1/P1S combos. I wanted to make some custom signs for my printers, but didn't want to stick anything to them. I also wanted to be able to take it apart in under 10 seconds for cleaning and maintenance and make it super easy to swap out signs. You can make anything from Hueforge prints, MakeMySign designs, or custom made STL's in your program of choice. This model is two pieces, left and right, that fit snugly under the front lip of the AMS to hold a printed sign. When spread out butting up against the inside of the feet it will hold a 250mm wide printed sign. In the attached photo I have used a width of 250mm and a height of 75mm and almost 3mm thickness. You could theoretically go taller, I just didn't want to cut off half of the printed AMS logo on the top right of the front face. The model will hold a print that is slightly over 3mm thick. It may pay to stay close to this thickness