Slicer Discord
AMS Drying Chock – Modelo 3D imprimible de MakerWorld MakerWorld
3D Printer Accessories

AMS Drying Chock

1.6k Descargas
1.2k Likes
631 Makes
Ver Modelo
Tired of re-dehydrating your desiccant bags? Sick of pre-drying filament rolls before every print? If you’re like me, you love experimenting with different materials but often skip over ones like Nylon because the drying process is just too much of a hassle.That’s where the AMS Drying Chock comes in. I designed this little wedge-shaped chock to keep the door of your BambuLab AMS system slightly open while allowing you to pump in hot air from a commercial filament dryer or a DIY PTC heater + fan setup. The result? Continuous, active filament drying for all your rolls—right inside the AMS.No more manual drying steps. No more giving up on certain materials. With this mod, you can integrate active filament drying directly into your AMS setup, ensuring every filament is perfectly dry and ready to go whenever you are.Check out my instagram or tiktok for my latest video on it. @stustu242To install this, you will need to print the following parts:1 x AMS Drying Chock (Left half)1 x AMS Drying
Categoría
3D Printer Accessories
Fuente
MakerWorld
Publicado
Actualizado
Lo que necesitas para imprimir: Principiante Baja confianza
¿Por qué?
2 colores
Pieza única 2 colores / AMS
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 0/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
Nylon
Colores
2 (AMS/MMU recomendado)
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección