AMS Filament Buffer Mount

I keep my p1s in a ventilated sound proof tool box with the AMS located on top. The 6 pin power cable could not reach between the printer and the AMS so I created two small mounts to change the location of the AMS filament buffer using minimal filament. The AMS filament buffer can now be mounted to the top side of the back panel using existing holes on the printer chassis. This allows the AMS 6 pin power cable to reach farther above the printer.The bolts that mount the brackets to the printer via the flush to body 2.8mm hole are M3 x 10mm bolts (you get two of these as spare extruder bolts with the printer, I used the external spool holder bolts which are also the same).The AMS filament buffer is then mounted using the bolts it was included with into the extruded 2.8mm hole. I suggest leaving the chassis bolts loose until the AMS filament buffer bolts are started. Then level the AMS filament buffer and tighten down the chassis mounting bolts and the AMS filament buffer bolts.The bolts