AMS Hub mount

I had an enclosure I built for my old Ender 3 so I decided to adapt it for holding my two BAMBU AMS units. The enclosure was a customised LAK table setup with removable Perspex sides. This enabled me to easily adapt the enclosure. I wanted the filament path to be short and as smooth as possible, so I mounted the hub to the enclosure. I designed a few versions of hub mounts before finding the configuration that allowed me to optimise the filament path. The adapter is simple to print but you will need two M3 x 25mm bolts and nuts to attach the hub to the adapter. I used two common timber screws to mount the adapter to the enclosure. I found a couple of these bolts in the spares I received with my X1E printer (same as shown below in the BOM). Cable lengthI accept no liability for any damage you cause to your system if you do not know what you are doing in attempting to follow what I did below. I also needed a longer 4 pin cable to go from the printer to the hub now the hub was not mounted