AMS Solid State Dehumidifier RS1

I had read about the solid state dehumidifier and my first thought was adding it to the Bambulabs AMS. This small module is great for something around 5L of volume. you could use on any flat surface. I printed the Gasket it PLA and used as a drill template, and also printed in TPU to be used as a gasket. Bill of Materials4 x M2x6mm2x M3x16mm to attached to AMS1 x Rosahl RS1 (solid state dehumidifier) https://www.chip45.com/prod/rosahl-rs1-micro-dehumidifier-membrane1 x VREG-2 USB (Powersupply) chip https://www.chip45.com/prod/vreg-2-usb-c-power-supply-module-rosahl-membranes Asssemblymount the RS1 in the case with 2 M2 screwsSolder 2 wires to the power supply as shown in the photo.insert the power supply into the case and feed wires through and out the base.solder the wires to the RS1. Make sure you get the polarity correct!!Use the drill template to drill the mount holes.mount the template and cut the square hole for the moisture extraction port.swap template for gasket and mount.