AMS Stacking Stand, Snap Together No Hardware

This model was printed using Bambu Basic PLA, with a total filament usage of 482g and a print time of approximately 13 hours.No supports are required.I designed this specifically for use with the AMS, but made sure the width is adjustable to also fit the AMS 2 Pro. Assembly Notes:I redesigned the front cross brace moving it upward in order to allow for more room when replacing spools. The assembly photos show the old front cross braces but the braces are labeled left and right on the print plates and stl files for clarity. Pay close attention to part orientation during assembly.Refer to assembly steps 1–7 for detailed guidance on correct alignment and fitting.The front cross braces are labeled left and right on the print plates so there won't be any confusion during assembly.Important: The snap-fit joints are intentionally tight for a secure hold. Once snapped into place, they cannot be disassembled without damage, so double-check orientation before final assembly.