Thingiverse
Amutorch BT35
von spazzedninny
0
Downloads
0
Likes
0
Makes
-Amutorch BT35 lens cover (no roll when used without ring grip)
-Amutorch BT35 lens cover with lanyard hole
-Amutorch BT35 lens cover with peep hole (use for brief periods when you want to spot something up close or check if you left your light on without removing the cover. See picture on low setting with peep hole cover)
-Amutorch BT35 body grip (wanted more grip and a larger body to grasp); Add support
TPU 95
I always run 8 shell instead of 100% infill and run 5 degrees hotter for better adhesion and a rougher texture.
*Note: body grip needs to be installed while print is warm to slide the lip over on the grip.
-Amutorch BT35 lens cover with lanyard hole
-Amutorch BT35 lens cover with peep hole (use for brief periods when you want to spot something up close or check if you left your light on without removing the cover. See picture on low setting with peep hole cover)
-Amutorch BT35 body grip (wanted more grip and a larger body to grasp); Add support
TPU 95
I always run 8 shell instead of 100% infill and run 5 degrees hotter for better adhesion and a rougher texture.
*Note: body grip needs to be installed while print is warm to slide the lip over on the grip.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
