Thingiverse
An optimzed kitchen sink strainer
door rupy
8
Downloads
3
Likes
0
Makes
After a few attempts, this is my optimised sink strainer.
You will likely have to scale it to your own sink.
It is slightly conical to perfectly fit.
The shared STL has a diameter of 49 at its base and 52.5 at its top.
I highly recommend using a temperature resistant filament, and moisture resistant. Hence, PLA is NOT recommended.
I printed in PETG which behaved really nicely for a full year until it received a large amount of boiling water and partially deformed... :)
Note:
Pouring warm water repeatedly on it will kind of anneal it, so it will slightly shrink over time.
You will likely have to scale it to your own sink.
It is slightly conical to perfectly fit.
The shared STL has a diameter of 49 at its base and 52.5 at its top.
I highly recommend using a temperature resistant filament, and moisture resistant. Hence, PLA is NOT recommended.
I printed in PETG which behaved really nicely for a full year until it received a large amount of boiling water and partially deformed... :)
Note:
Pouring warm water repeatedly on it will kind of anneal it, so it will slightly shrink over time.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!