Thingiverse
anchor trolley fairlead/guide
por jonnyg30
95
Descargas
69
Likes
0
Makes
A basic single bolt fairlead for kayak anchor trolley.
print settings are quite open for this one so go for what ever makes you happy but below is what the part was created at.
material: ABS
increased all axis 2%
layer height: 0.2mm
infill: 100%
supports: no
Print Speed: 40mm/s
ext temp: 240C
Print time: just over 1 hour
print settings are quite open for this one so go for what ever makes you happy but below is what the part was created at.
material: ABS
increased all axis 2%
layer height: 0.2mm
infill: 100%
supports: no
Print Speed: 40mm/s
ext temp: 240C
Print time: just over 1 hour
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!