Thingiverse
Ancient ballista model
di stephen_w
13
Download
32
Likes
0
Makes
Ancient ballista model
I had made a Ancient ballista model, Installation instruction is shown in the picture.
Hope you like it.
Special tips
You need a bungee cord (length 180mm ,diameter 2mm~3mm)
This model was printed using PLA. (fill in 10%，using a lower layer hight (0.15/0.2mm)，no support)
I had made a Ancient ballista model, Installation instruction is shown in the picture.
Hope you like it.
Special tips
You need a bungee cord (length 180mm ,diameter 2mm~3mm)
This model was printed using PLA. (fill in 10%，using a lower layer hight (0.15/0.2mm)，no support)
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
