Thingiverse
Android Things Pico Pro Maker Kit Case
by theniterat
1
Downloads
0
Likes
0
Makes
Was given an Android Things Dev kit as a gift... While novel wasn't a fan of the google cardboard stand so I created my own case.
This currently has 2 large areas of improvement needed.
1. screen panel needs to be moved 2-3mm closer to the board. at it's current state the cable it's as tight as can be and pushed against the solder points.
2. Support pin on the bottom needs to be resized and shifted to the corner more. Currently it it pressing against the screen cable
There are a few other cleanup areas that I'd like to address but since I don't really use it all that often it may be some time before I get around to it.
This currently has 2 large areas of improvement needed.
1. screen panel needs to be moved 2-3mm closer to the board. at it's current state the cable it's as tight as can be and pushed against the solder points.
2. Support pin on the bottom needs to be resized and shifted to the corner more. Currently it it pressing against the screen cable
There are a few other cleanup areas that I'd like to address but since I don't really use it all that often it may be some time before I get around to it.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
