Thingiverse
Learning
Model downloaden
Anemometer for Raspberry Pi
41
Downloads
24
Likes
0
Makes
Anemometer for a raspberry pi.Use either a Hall effect or Reed Switch hot glued to the side via the opening the body. Hot glue a neodymium magnet onto the threaded rod.
Requires:
2 x 608z bearings
5 x M8 nuts
3 x washers
Threaded Rod
The main body can be screwed down. This was one feature I wanted, the ability to screw the Anemometer to the roof of an allotment shed. Cups are push fit into the center ring. You could either super/hot glue or PLA weld the cups into place.
Unsure on RPM. When tested with a drill bolted to the threaded rod one cup flew out at a very HIGH RPM.
Build guide coming soon via Instructables.
Requires:
2 x 608z bearings
5 x M8 nuts
3 x washers
Threaded Rod
The main body can be screwed down. This was one feature I wanted, the ability to screw the Anemometer to the roof of an allotment shed. Cups are push fit into the center ring. You could either super/hot glue or PLA weld the cups into place.
Unsure on RPM. When tested with a drill bolted to the threaded rod one cup flew out at a very HIGH RPM.
Build guide coming soon via Instructables.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
