Thingiverse
Anet 32bit
by Far_a_way
23
Downloads
12
Likes
0
Makes
Do you want to upgrade your Anet E12 / E16 with 32bit?
Here is a small guide!
Requirements more than mediocre !!
Required materials:
1 piece SKR mini V1.1 dimensions 90x70mm
in addition to 4 stepper drivers
1 piece of mosfet for heatbed
1 pc board adapter
1 piece of mosfet holder
as well as cables, dexterity and programming skills (marlin 2.0)
Print out the circuit board adapter and mosfet holder.
Remove the printer and disconnect it from the mains, open the housing and remove the mainboard.
Now the SD card slot 18mm wide and the USB port 14mm have to be refined,
towards the display. You need a file that is narrower than 1.6mm for the SD card slot. When this is done, the board adapter and the SKR
Board mounted, check whether the USB slot / SD card fits. Mosfethalter and
Mount the mosfet.
Special cable EXP1 to ANET-LCD; You need 26cm 10pin. Flat cable and
2 10-pin Tub connector. On the EXP1 side, remove the 4th wire from the composite,
comes with a 1pin DuPont
Here is a small guide!
Requirements more than mediocre !!
Required materials:
1 piece SKR mini V1.1 dimensions 90x70mm
in addition to 4 stepper drivers
1 piece of mosfet for heatbed
1 pc board adapter
1 piece of mosfet holder
as well as cables, dexterity and programming skills (marlin 2.0)
Print out the circuit board adapter and mosfet holder.
Remove the printer and disconnect it from the mains, open the housing and remove the mainboard.
Now the SD card slot 18mm wide and the USB port 14mm have to be refined,
towards the display. You need a file that is narrower than 1.6mm for the SD card slot. When this is done, the board adapter and the SKR
Board mounted, check whether the USB slot / SD card fits. Mosfethalter and
Mount the mosfet.
Special cable EXP1 to ANET-LCD; You need 26cm 10pin. Flat cable and
2 10-pin Tub connector. On the EXP1 side, remove the 4th wire from the composite,
comes with a 1pin DuPont
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!