Anet 8 Z switch mount

I found this POWER switch box designed by AEGGSBAERDE. It looked perfect for adding a switch to my Anet 8.but. after printing it I could not find a rocker switch small enough . I purched a switch at Lowe's. then redesigned the box to fit my switch. Larger front switch opening , added a larger rear hole for bigger wires.I added a guset to the rear to pull it away fron the Z motor for more wire room. I elongated the screw holes. If using PLA you will need to shave a little off the side retaining clip the force may be too strong and break PLA

Revised..2/4/20. added extra rear hole and added a slot in switch hole to allow for strong spring that was spredding this case