Thingiverse
Anet A2 Supports
door CrypticCircuits
25
Downloads
15
Likes
0
Makes
These are brackets to support the top frame of the Anet A2. They fit two 1/2 inch square tubes and are easy to print. They are a bit tricky to install but not impossible, just make sure you can lift and move the printer to help with installing them.
Items needed
- 1/2 inch square tubes 16 inch each
- M5 hammer nuts
- M5 cap screws or Philips no matter
- Drill
Items needed
- 1/2 inch square tubes 16 inch each
- M5 hammer nuts
- M5 cap screws or Philips no matter
- Drill
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!