Thingiverse
Anet A2 X-Axis Cable Chain Attachment
by hartmann1301
22
Downloads
16
Likes
0
Makes
Some parts to attach an energy cable to the x-Axis of the Anet A2.
The part where the energy cable starts next to the first z-Axis is not perfekt. I had to use hot glue to make it work well.
15.05.2018: I edited this part a bit, it should be better now.
The slider-screw at the end the energy cable needs to longer than the original one. This was no problem for me because I used already a long one because of the belt-tensioner.
It fits to the cheap 10x10 energy cables you can by from ebay. (or somewhere else)
The part where the energy cable starts next to the first z-Axis is not perfekt. I had to use hot glue to make it work well.
15.05.2018: I edited this part a bit, it should be better now.
The slider-screw at the end the energy cable needs to longer than the original one. This was no problem for me because I used already a long one because of the belt-tensioner.
It fits to the cheap 10x10 energy cables you can by from ebay. (or somewhere else)
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!