Thingiverse
Anet A6 Light sockets
by Dojec
0
Downloads
1
Likes
0
Makes
This sockets can be mounted on top of the ANET A6 printer to light the heatbed. There are 2 holes available on the side.
You need to solder 4 LEDs of 3mm and 1 resistor of 100 ohm in serie.
Insert them on the outside in the holes to have the correct distance.
Once the soldering is done, put them on the inside.
It's a tight fit. If you want to be more comfortable, best make the height a bit bigger. But with tweezers I managed to fit it like it is.
Run the cable to the 12V+ and ground of the power supply , best put a switch in between.
You need to solder 4 LEDs of 3mm and 1 resistor of 100 ohm in serie.
Insert them on the outside in the holes to have the correct distance.
Once the soldering is done, put them on the inside.
It's a tight fit. If you want to be more comfortable, best make the height a bit bigger. But with tweezers I managed to fit it like it is.
Run the cable to the 12V+ and ground of the power supply , best put a switch in between.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
