Thingiverse
Anet A6 Raspberry Pi Case Bracket
von mrubesch
3
Downloads
1
Likes
0
Makes
A bracket to mount [0110-M-P's Raspberry Pi case](https://www.thingiverse.com/thing:922740) on the upper left corner of the Anet A6 frame.
The curved slot opening attaches to the screw for the little stop that held down the z axis bar. The other hole attaches to the screw holding the top left corner of the frame.
Requires a longer (M3 x 20) screw to replace the top left frame screw. The z axis bar stop screw is reused. Requires four M3 x 10 screws to attach the case to the bracket.
Various thicknesses are probably overkill, but I wanted to leave airflow space for the bottom of the Pi, and I was going for quick and dirty in my 3D drawing.
The curved slot opening attaches to the screw for the little stop that held down the z axis bar. The other hole attaches to the screw holding the top left corner of the frame.
Requires a longer (M3 x 20) screw to replace the top left frame screw. The z axis bar stop screw is reused. Requires four M3 x 10 screws to attach the case to the bracket.
Various thicknesses are probably overkill, but I wanted to leave airflow space for the bottom of the Pi, and I was going for quick and dirty in my 3D drawing.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
