Anet A6 Z Stop Switch Bracket

After printing and installing https://www.thingiverse.com/thing:2106854 , The z stop switch on my printer was no longer being hit. To remedy the issue, I created this bracket that lowers and moves the switch to a position that will be hit by the new x axis cars. It uses the existing z stop switch mounting holes on the printer so there is no need to drill.

V2 update - the initial bracket made the switch just touch the the flat part of the car. That worked fine, but I was unsure if wear would eventually allow the car to move down slightly farther over time so I made an update to push the switch well under the flat part.

V3 update - I switched out build plates to a anycubic ultrabase which has a glass plate on the bed, so I needed to move the switch again. I modded the bracket to support both heights.