Thingiverse
ANET A8 3D printer Z Axis tool
por M0PWX
22
Descargas
11
Likes
0
Makes
i was finding every time is changed the filament the Z Axis went out of line (took me a while to figure this out) so now i reset the Z Axis level every time i change the filament
this very simple tool makes it easy to setup the dual Z Axis motors on the ANET A8 or others with a similar dual stepper Z Axis system
you will need to print 2 of these tools
process is
1:- turn off the stepper motors,
2:- manualy move the Z Axis up to allow you to slip the two tools around the 8mm guide bars
3:- manually lower the Z Axis until it touches the tools,
4:- then raise a fraction (same amount both sides) so the tools can be romoved
5:- home the Z Axis
your Z Axis should now be level and you can level the bed
this very simple tool makes it easy to setup the dual Z Axis motors on the ANET A8 or others with a similar dual stepper Z Axis system
you will need to print 2 of these tools
process is
1:- turn off the stepper motors,
2:- manualy move the Z Axis up to allow you to slip the two tools around the 8mm guide bars
3:- manually lower the Z Axis until it touches the tools,
4:- then raise a fraction (same amount both sides) so the tools can be romoved
5:- home the Z Axis
your Z Axis should now be level and you can level the bed
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!