Thingiverse
Anet A8 AM8 Electronics Box
von michaeldeberry
301
Downloads
214
Likes
4
Makes
This is an electronics enclosure for the AM8 - Metal Frame for Anet A8 mod found here: https://www.thingiverse.com/thing:2263216
To use this mod the x axis motor must be mounted from the front. Doing so will require the operation of the motor to be inverted.
If you are using marlin, or skynet, you can accomplish this by changing INVERT_X_DIR from false to true.
For the stock firmware this should be able to be accomplished by reversing the wire order for the connector. However, I haven't test this and I would recommend updating your firmware if you haven't already.
This case was designed to be used with a fan, and I wouldn't recommend using it without one.
## Printed Parts
### Frame
The Anet mainboard mounts to the back of the frame. There are two variants of the frame included, one supports a 80mm fan and one supports a 90mm fan.
8/15/2017 - Added 80mm and 90mm frame variants that have mounts for a RAMPS v1.4 board. The initial frame versions may, or may not, be
To use this mod the x axis motor must be mounted from the front. Doing so will require the operation of the motor to be inverted.
If you are using marlin, or skynet, you can accomplish this by changing INVERT_X_DIR from false to true.
For the stock firmware this should be able to be accomplished by reversing the wire order for the connector. However, I haven't test this and I would recommend updating your firmware if you haven't already.
This case was designed to be used with a fan, and I wouldn't recommend using it without one.
## Printed Parts
### Frame
The Anet mainboard mounts to the back of the frame. There are two variants of the frame included, one supports a 80mm fan and one supports a 90mm fan.
8/15/2017 - Added 80mm and 90mm frame variants that have mounts for a RAMPS v1.4 board. The initial frame versions may, or may not, be
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!