Thingiverse
Anet A8 bed level calibration test
por NeoCortex
1.4k
Descargas
807
Likes
3
Makes
This is the test I came up with for my Anet A8 bed level.
It goes all around the bed 2 times and prints 2 10x10x5mm cubes in the center.
It prints 2 lines right next to each other.
If your bed level is on point, you can see a small gap between them. (picture 1)
If it's to low it presses the lines into each other. (just a bit is fine - picture 2)
If it's to high, you will see the filament not sticking to the bed.
No brim, raft, rift! No infill!
Turned out to be a pretty good testing methode.
It goes all around the bed 2 times and prints 2 10x10x5mm cubes in the center.
It prints 2 lines right next to each other.
If your bed level is on point, you can see a small gap between them. (picture 1)
If it's to low it presses the lines into each other. (just a bit is fine - picture 2)
If it's to high, you will see the filament not sticking to the bed.
No brim, raft, rift! No infill!
Turned out to be a pretty good testing methode.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!