Thingiverse
Anet A8 bed level test
von SIMKEH
757
Downloads
407
Likes
1
Makes
Use this to set up your bed leveling correct. On the photo you can see, in the front right corner it is too far away, and in the front left too near. Print this, adjust your bed screws and then print again.
Feel free to donate a buck if it helped you :)
#Get your Anet A8 here: #
(click on the image)
Feel free to donate a buck if it helped you :)
#Get your Anet A8 here: #
(click on the image)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
