Anet A8 Bed Probe Mount

This is a mount to hold a 12mm Inductive Probe to the extruder bracket on the Anet A8
It is installed behind the part cooling fan using the same screws that came with the printer

I am also using the Spriya Fan Duct, a fantastic improvement over the original fan duct - the probe holder is compatible with fan ducts that fit over as well as inside the mouth of the fan:
https://www.thingiverse.com/thing:2133328

Wiring:

I would highly recommend this site as it is where I found most of the information I needed, and it provides information for a number of different models of probes and methods for connecting your probe, so you can choose what will work best for you:
https://3dprint.wiki/reprap/anet/a8/improvement/autobedleveling


Firmware Configuration:
Probe Offsets:
The Probe is about 40mm in front of and 50mm to the right of the nozzle.

I would also advise setting the firmware so that it thinks that the probe is 1mm below the nozzle. This means that the probe triggers