Thingiverse
Anet A8 Cable Chain Custom
989
Download
792
Likes
8
Makes
UPDATED! Open cable chain links and clip. Clip design adapted from schnuffi's design and slapped onto my thinned variation of the cable chain by sukhoi27
I included the X Axis extruder end and motor mount by The_Random_Engineer which I plan on tweeking in a later date.
Thinning the cable chain made by sukhoi27 and chamfering the inner chain edge for ease of assembly. I also cleaned up the Y-Bed bracket of unnecessary geometry and thinned the wall to fit the profile of my chain.
I mounted it to my Anet A8 using M4.7x12mm screws and nuts. Though the nuts probably weren't needed and you may be able to get away without using screws like Papinist did with his thinned bracket design. I just like it sturdy.
I also added holes to the Y-Bed bracket to accommodate a zip tie to act as a strain relief for the wires which I soldered directly to the board (14ga.). Holding them in place securely.
P.S. After installation I started hearing squeaking. After much searching and fear of bad
I included the X Axis extruder end and motor mount by The_Random_Engineer which I plan on tweeking in a later date.
Thinning the cable chain made by sukhoi27 and chamfering the inner chain edge for ease of assembly. I also cleaned up the Y-Bed bracket of unnecessary geometry and thinned the wall to fit the profile of my chain.
I mounted it to my Anet A8 using M4.7x12mm screws and nuts. Though the nuts probably weren't needed and you may be able to get away without using screws like Papinist did with his thinned bracket design. I just like it sturdy.
I also added holes to the Y-Bed bracket to accommodate a zip tie to act as a strain relief for the wires which I soldered directly to the board (14ga.). Holding them in place securely.
P.S. After installation I started hearing squeaking. After much searching and fear of bad
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
