Thingiverse
Anet A8 case
von kupec123
1
Downloads
1
Likes
0
Makes
Simple case for Anet A8 Motherboard
80mm Pc fan
0.2 Layer
Support Everywhere
30 % infill case and 10 % infill for Lid if u use clear filament
Once case is printed whit support everywhere you can remove left or right support for more cable holes if needed
.
Cheers!
80mm Pc fan
0.2 Layer
Support Everywhere
30 % infill case and 10 % infill for Lid if u use clear filament
Once case is printed whit support everywhere you can remove left or right support for more cable holes if needed
.
Cheers!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
