Thingiverse
Anet A8 Corner brackets/mounts V2
von MakeCents
8
Downloads
3
Likes
0
Makes
I made these corner mounts to hold my spools. Added my vertical and remix of the rolling spool holders that mount to the spinning cross bar.
Corner pieces: Put the rear in first, then start the center and gently snap in the side while pressing down the center.
Spinning part: Has extra lines to sand for preferred resistance in spin.
This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/4vHkne4hk8Z
Corner pieces: Put the rear in first, then start the center and gently snap in the side while pressing down the center.
Spinning part: Has extra lines to sand for preferred resistance in spin.
This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/4vHkne4hk8Z
MakeCents veröffentlicht auch auf
12 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
