Anet A8 corner clip

Usage
--------
Clips an 1mm CFK plate (220x220) onto the A8's normal heating bed.
CFK plate and heating bed together together, having a thickness of approx 4.2mm.
Use same corner 4 times. No additional material needed.

Installation
--------------
No need to diassemble the plate nor the heating bed, screw or spring. Just push down the spring from the beds bottom towards its carrier using a pliers or a screwdriver. Then snap-in the corner and release the spring.
After spring has been released, the corner will be held in place by the spring.

Pros
------
Very tiny CFK plate holder which is unlikely to collide with any parts attached to the printer head as eg. bed level sensor, cooler ducts or the like.