Anet A8 Dual Bowden Conversion

Really liked this design, however I wanted to keep my X-Axis chain and needed a mount for the Tronxy sensor.

I pulled the blower fan mount a tad further away from the X-Carriage mount as I felt it was a bit too tight. I made an attempt at partitioning the fan output so that there was equal flow to each hot end, though it's not as equal as I'd like still - thus I used tape for now.

Also opted to use https://www.thingiverse.com/thing:2356276 by TGYK for the hot end fan.

Printed in ABS, and has held up quite nice for some 24+ hour prints.

For my set up, I ended up having the second extruder at (X-32.25, Y0).

I might also adjust the rear anet_dual_x_carriage_v4 since my X-axis belt was rubbing and I added some spacers for the rear Tronxy mount (which isn't clear in the photos).