Anet A8 E3D Mount with BLTouch

I remixed ikarisan's mounts to create one that had the BLTouch option but used Hex bolts instead of the square ones he had used.

UPDATE - I snapped the BLtouch mount clean off while installing the nuts that hold the X axis belt. The rest of the mount is perfect however so I have updated the mount with some reinforcement.

V2 - Changes made as follows:
Added reinforcement around BLTouch mount
Removed some additional screw holes that weren't required for Anet A8 style back plate
Adjusted the position of the hot end mount down a few mm as it was quite far from the bed meaning that the levelling screws were almost at their stops.

V3 - Changes made as follows:
Removed some of the reinforcement from the base of the BLtouch mount as it was preventing the sensor from mounting flat/flush.