Anet A8 Enclosure Brackets

These eight (8) brackets are utilized to assist in forming an enclosure for the Anet A8. There are other materials needed for this enclose that cannot be printed but I will provide a list of materials below.

*To note* This is still a work in progress and I will provide some pictures of the build as it progresses.

These brackets are designed to be used with two different sized cuts of wood: 1.5" x 1.5" x (length of your choice) and 1.5" x .5" x (length of your choice) I started with some pre-cut lumber from a local hardware store then cut down to size.

The quantities and sizes of the wood in imperial standard are below:

1.5" x .5" x 27" - 4 pieces (These are the top and bottom supports in the front and back of the enclosure)

1.5" x .5" x 21" - 2 pieces (These are the side top supports)

1.5" x 1.5" x 16" - 4 pieces (These are the upright supports in the corners)

1.5" x 1.5" x 21" - 2 pieces (These are the side bottom supports)

You will need 8 screws (3/4" len