Anet A8 Frame table mount

created to dampen vibrations caused by Y axis movement. Helps stiffen the frame significantly. I put one one each on the front over the 8mm threaded rods, and one in each back corner. screwed directly to my table, or you could use plywood underneath. Rear mount has a cutout for cables to run through.

Small update: for those of you unsure on whether this will help, I have been using them now for 3 weeks and there is an insane difference between prints before and after. my prints hardly have any wobble or shift in them whatsoever now.

Edit: modified rear bracket to have a looser tolerance. It should fit snug now on the rear acrylic.

Edit 2: Uploaded a J-hook bracket for more mounting options