Thingiverse
Anet A8 Hotbed Cable Guide
por cehbab
126
Descargas
67
Likes
0
Makes
This is a cable strain guide for an Anet A8 hotbed cable.
My plug was beginning to burn out as the connector plug was not a tight fit, and so I soldered them directly to the hotbed. I made this cable guide to stop solder movement. It mounts to the H aluminium frame underneath the hotbed, and to make this work I had to rotate the hotbed left 90 degrees and mounted it just past the bearing.
The cables are a tight fit, but tightening the cable management spiral allowed it to slip through the gap. If its too loose for your wires then you can use a small cable tie to tighten further.
The aluminium H plate was 3mm and this piece was a tight fit there as well printed with ABS.
My plug was beginning to burn out as the connector plug was not a tight fit, and so I soldered them directly to the hotbed. I made this cable guide to stop solder movement. It mounts to the H aluminium frame underneath the hotbed, and to make this work I had to rotate the hotbed left 90 degrees and mounted it just past the bearing.
The cables are a tight fit, but tightening the cable management spiral allowed it to slip through the gap. If its too loose for your wires then you can use a small cable tie to tighten further.
The aluminium H plate was 3mm and this piece was a tight fit there as well printed with ABS.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!