Anet A8 Igus Blocks

I made these as the 3d printed blocks I had caused too much binding. These allow you to secure the IGUS bushing with 2 zip ties, rather than completely encompassing it.

The 2 versions present are as follows:

AnetA8BedIgusBlocks.stl: The version i have printed and am currently using. It works well, the bearings are held securely. The bed is a few mm higher than what i had, but I'm fine with that.

AnetA8BedIgusBlocksV2.stl: For added security, for those who are concerned about a bearing popping out, this should block them in, at either end, whilst they are secured with zip ties.

AnetA8BedIgusBlocksV3.stl: AS per the update below, i have added in a part that should hit the end stop instead of the bearing and keep things positioned correctly. I have also decreased the side of the mounting screw holes to ensure a tight fit when screwing - this can always be drilled out if they are too tight.

Note: I haven't printed AnetA8BedIgusBlocksV2.stl so not 100% sure if it works as