Anet A8 Mosfet Case

This is a mosfet case that i designed for the Anet A8.
This is designed to hold 2 mosfets (one for hot bed, and one for the hot end.)
This is not designed to work with the T-Frame braces (will edit for that is needed)
This will however work with the frame braces that Leo made for the X wobble.
If using with a X wobble brace you will need 1 M3*25mm self tapping screw
for bottom mount hole you will need a M3*12-16mm (no longer than 16mm) selt tapping screw.(use this for both is no frame brace.)

Some sanding maybe required for the mosfet to fit into the holders. as mass made PCBs are made in large sheets then snapped apart. so not all are the exact same width. (one of mine fit perfect, but the other i grinned down a bit on each side)

I have added a modified one to work with C_Wolseys Original case design.

I might edit another veraion of this for the mks mosfet soon if people would be interested in that as well.

this goes along with the case that i remixed from another