Thingiverse
Anet A8 mounting brackets
door itsatrap
136
Downloads
102
Likes
1
Makes
Brackets to mount Anet A8 backside to a sheet of wood.
I was looking for a way to screw down my printer for more rigidity. I'm using a [frame brace on the front](https://www.thingiverse.com/thing:2397219) with mounting holes in it but I wanted to secure the backside as well so I designed these.
The parts use the existing bolts and nuts already on the printer, it fits perfectly for me.
For slicing, I put the models on their backs in Cura (so with the 2 small and the big holes on the build plate). On that side there is a little rectangle indent. I put support on for it, not sure if it's really necessary (I'm new to this hobby). But it printed perfectly that way.
Extra parts needed to screw down the brackets:
- 4 screws. Mine were 3.5mm wide and about 20mm long.
- a sheet of wood. Mine was 18mm thick.
I was looking for a way to screw down my printer for more rigidity. I'm using a [frame brace on the front](https://www.thingiverse.com/thing:2397219) with mounting holes in it but I wanted to secure the backside as well so I designed these.
The parts use the existing bolts and nuts already on the printer, it fits perfectly for me.
For slicing, I put the models on their backs in Cura (so with the 2 small and the big holes on the build plate). On that side there is a little rectangle indent. I put support on for it, not sure if it's really necessary (I'm new to this hobby). But it printed perfectly that way.
Extra parts needed to screw down the brackets:
- 4 screws. Mine were 3.5mm wide and about 20mm long.
- a sheet of wood. Mine was 18mm thick.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
