Anet A8 Plus QuadFusion Mount

This mount was made to hold the QuadFusion print head on the Anet A8 Plus printer. There are currently two versions of this mount. A third one will be coming soon. The details for the mount are below. (Not sure why some pictures are upside down)

Mount Versions:
- Basic Mount - No LEDs
- Mount With 2 LEDs - Will hold 2 5mm LEDs
- Mount with Inductive Sensor - Coming Soon...

Hardware Used:
4 - M4-0.70 Nylon Lock Nuts (Used these so they don't come loose during a print.)
2 - M3-0.50 Nylon Lock Nuts (Used these so they don't come loose during a print.)

2 - M3-0.50x15mm Countersunk Style Screws (Used to hold print head to mount)
4 - M4-0.70x35mm Pan Head Screws (These hold the rear mount to the front mount)
To attach this mount to your printer you can use the original screws (12 screws)

Install Instructions:
- Gently tap the 6 required nuts into the mount. They will be tight but they will fit when tapped in. (Your print quality could cause issues) (See picture to see nu