Slicer Discord
Anet A8 Plus Z Leveling Tool – 3D-Druckmodell von Thingiverse Thingiverse

Anet A8 Plus Z Leveling Tool

von Indychus
102 Downloads
62 Likes
0 Makes
Zum Modell
*** This is designed in mm. If your slicer expects inches when you import this, it will be very tiny and you will have to scale it by 25.4 (2540%) ***

This is a simple tool to help level your Z Axis. Simply snap them onto the Z rods below the X axis and then turn the Z screws by hand until it bottoms out against the tools. Then use the machine interface to drive the Z axis up off of the tools. Store on the base when not being used.

The base takes a good bit of force to snap into the extrusion channel.

This is designed specifically for the Anet A8 Plus, but should work on any printer with a similar extrusion profile and 8mm guide rods.
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen