Thingiverse
Anet a8 probe mount
von alessandrostars
2
Downloads
4
Likes
0
Makes
This is a mount for the blu probe.
On marlin I use -39x and -46y.
You can use these probe for fine tuning and improve rigidity.
On the mobile part's hole you have to put a 3mm nut and a 3M*30 screw on the vertical hole to set the probe's height.
To fix probe to the mount I used 3M*40 screw and 3mm nut
On marlin I use -39x and -46y.
You can use these probe for fine tuning and improve rigidity.
On the mobile part's hole you have to put a 3mm nut and a 3M*30 screw on the vertical hole to set the probe's height.
To fix probe to the mount I used 3M*40 screw and 3mm nut
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!