Thingiverse

Anet A8 - Simple Sample Holder

por Hachiro

4 Descargas

2 Likes

0 Makes

Needed something for sample spools / pen samples.
Couldn't find anything on here, so here's this :)
Being that it's attached to the X axis, the print head MAY be a bit slower, but it shouldn't be too bad. It'll also help the sample filament to not go flying everywhere :)

Things to do:
cut out a bit more for the middle two holes, so the screws can be flush against the part.

Otherwise, it works fine ^-^

Changelog;
May 6, 2017: Uploaded version 2. This should stop sample filament from falling off.
Not tested yet, but it should be in a few days.

Dec. 24, 2017: I don't remember making this non-commercial.. License changed to be CC - attribution - share alike.
I also will no longer be messing with this model, so go ahead an remix it if you want.