Thingiverse
Anet A8 Spool Holder
von Shumanator03
1
Downloads
0
Likes
0
Makes
I tried a few spool holders for the top of my Anet A8 but didn't like them so I modeled my own!
Uses the threaded bolt and nuts that comes with he stock filament holder
Made to snap over the back of the screen on the STOCK Anet A8 acrylic. When putting on needs just a slight bit of force. made so center of mass of the filament spool is more inline with the supports.
Can be printed on Anet a8 but only one at a time.
Please leave a comment with what you thought
Uses the threaded bolt and nuts that comes with he stock filament holder
Made to snap over the back of the screen on the STOCK Anet A8 acrylic. When putting on needs just a slight bit of force. made so center of mass of the filament spool is more inline with the supports.
Can be printed on Anet a8 but only one at a time.
Please leave a comment with what you thought
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
