Thingiverse
Anet A8 Switch Box
door JMadison
6
Downloads
6
Likes
0
Makes
This is a back facing rather than a side facing switch box. It doesn’t enclose the power supply terminals.
Prints: Box, Top, Cable Clamp.
I hesitated publishing this because it's of no use unless you have or can get the switch that I used or one the same size (see PNG)
http://www.ebay.com/itm/like/221725745452
Also, the box uses screw holes available on the specific model of Anet A8 power supply that came with my kit (although I have noticed the same hole pattern on other power supplies)
Materials:
(5) M3 x 6
(2) M3 x 10
(2) M3 x 20
(2) M3 nylon lock nuts (or regular and use locktite)
(2) M3 nuts
Other:
I didn't remove the power supply to take the photos, I have a spare.
Prints: Box, Top, Cable Clamp.
I hesitated publishing this because it's of no use unless you have or can get the switch that I used or one the same size (see PNG)
http://www.ebay.com/itm/like/221725745452
Also, the box uses screw holes available on the specific model of Anet A8 power supply that came with my kit (although I have noticed the same hole pattern on other power supplies)
Materials:
(5) M3 x 6
(2) M3 x 10
(2) M3 x 20
(2) M3 nylon lock nuts (or regular and use locktite)
(2) M3 nuts
Other:
I didn't remove the power supply to take the photos, I have a spare.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
